Usage of WD-40 for Sewing Machines

WD-40Honestly put, there is a lot of controversy regarding the use of WD-40 for sewing machine. Even though the risk factor is included, many people still end up using it. But it is must that if you are doing something, better do it the proper way which will yield the best results. There is right way to use WD-40 and there is also definitely a wrong way to use WD-40. The  Most common misconception is that it is sewing machine oil, which is mostly wrong. This is a solvent of some sort, which provides many useful advantages to the best sewing machine, that we will learn in this guide.

Tips to Use WD-40 for Sewing Machine:

Tip of sewing machine

  1. Usage as a Solvent: Many people have been using WD-40 for a very long time on their machines without any detrimental effect. Some use it for the first time and then end up with a frozen device. This is because it was used as a lubricant which is not its purpose. Actually, it does the job of a solvent. What it does is that it breaks down the gummy old oil extremely well. If you are incapable of removing the WD-40 afterwards, it will continue to break the oil and definitely result in freezing. You have to successfully remove the WD-40. This can be achieved by using flannel rags and an air compressor. It will remove the solvent and the gunk it dissolves. Even an air compressor can be used, but it must have good pressure, if it is to do the job properly.
  2. Removing Old Oil: Many times you would discover that someone used the wrong oil on the machine. This can be due to a certain somebody operating your machine or even a previous owner who didn’t know the best oil for the health of their product. The old oil can be effectively removed by the use of WD-40 due to its solvent nature. Just scrub on the solvent on the machine, then use any brush to wipe the machine. You can even use sandpaper which will make it easier to remove. So it can be seen that using the oil for the purpose it has been made is perfectly safe to be employed for sewing machines.
  3. Procedure: Blow out all the lint using an air compressor. Spray the gummed up area generously with WD-40. Then work with all the mechanisms until they are moving again freely. Employ an air compressor and blow out all the oil. This will surely take a while. Make sure that there are no wet spots left on the machine. Turn the wheel so that you get to all sides of the sprayed parts. Use flannel rags to clean up. Now apply the new proper oil.
  4. Precautions: A few words of precautions to keep in mind. Using this penetrating oil for the purpose it has been made is the way to go. There is no point in listening to controversies without evidence. There are some situations where use of WD-40 is not advised such as on certain industrial machines and longarm quilting machines. They have porous bearings that hold onto the WD-40 which is not proper. Some people say that using WD-40 made the matter worse. Well that is because one has to remove the oil after application. If not, then matters would certainly get worse. Also, some people say just to apply the new oil right on the old gummy one without removing it. That will make the machine much worse. That is why WD-40 exists; simply to remove the old gunk. You may take on controversies exactly how they are presented to you or you may go out, experiment and find out for yourself, the proper way.

How it will effect also depends upon the way you apply and the method you use it to manage all the cleaning work. If you are well aware of the uses, benefits and the risk factors, you will be in a better place to take the most out of it and get benefitted. Otherwise, if you have planned to use this agent, you may require a little assistance to know, how to use it in an effective manner. For more help regarding how to maintain your sewing machine read here…

Leave a Reply

Your email address will not be published. Required fields are marked *